Installation Instructions for SLES: ----------------------------------- o Make sure "kernel-source" and "kernel-sysms" packages are installed o Copy binary RPMS to /usr/src/packages/RPMS/ directory Where is x86_64, i586 etc. o Install binary RPM based on the architecture (x86_64, i586 etc.) and kernel type (xen, smp, default etc.) e.g., # uname -a Linux qlge-test1 2.6.16.60-0.21-smp #1 SMP Tue May 6 12:41:02 UTC 2008 x86_64 x86_64 x86_64 GNU/Linux In the above example, architecture is x86_64 and kernel type is "smp", so install "smp" flavour of x86_64 RPM rpm -ivh /usr/src/packages/RPMS/x86_64/-qlge-kmp-smp-_-.x86_64.rpm o After binary rpms are installed, run "modinfo qlge" and verify driver version is o Run "modprobe qlge" to load "qlge" module can be obtained using "uname -r" Installation Instructions for RHEL: ----------------------------------- o Make sure "kernel-headers" package is installed o Set RPM_BUILD_ROOT to /usr/src/redhat for RHEL 5.x /root/rpmbuild for RHEL 6.x o Copy binary RPMS to $RPM_BUILD_ROOT/RPMS/ directory Where is x86_64, i686 etc. o Install the binary RPM based on architecture (x86_64, i686 etc.) and kernel type (PAE, xen etc.) e.g., #uname -a Linux qlge-test2 2.6.18-164.el5 #1 SMP Tue Aug 18 15:51:54 EDT 2009 i686 i686 i386 GNU/Linux In the above example, architecture is i686 and kernel type is "PAE", so install "PAE" flavour of i686 RPM rpm -ivh $RPM_BUILD_ROOT/RPMS/i686/kmod--qlge-PAE--.i686.rpm Note: In case of RHEL5.x use --nodeps option to avoid GRO/AER related missing symbols. o After binary rpms are installed, run "modinfo qlge" and verify driver version is o Run "modprobe qlge" to load "qlge" module can be obtained using "uname -r" Installation Instructions for Citrix XenServer: ----------------------------------------------- o Copy the binary rpm to XenServer. Install it there rpm -ivh -qlge-modules-xen---.i386.rpm. e.g., rpm -ivh -qlge-modules-xen-2.6.27.42-0.1.1.xs5.6.0.44.111158-1.0.0.29-00.i386.rpm o After binary rpms are installed, run "modinfo qlge" and verify driver version is o Run "modprobe qlge" to load "qlge" module can be obtained using "uname -r" Uninstalling the driver ----------------------- 1. Unload the driver module modprobe -r qlge" Note: * qlge : "ERROR: Module qlge is in use" message may be seen while unloading qlge module If you see the above error message during unload of the driver, retry the module unload after performing "service netqlremote stop" 2. List the installed qlge RPMs rpm -qa | grep qlge 3. Remove the unwanted qlge RPMs using "rpm -e "