Products/HA/DellRedHatHALinuxCluster/Storage/PowerVault MD3000i/Introduction

From DellLinuxWiki

Jump to: navigation, search

Dell|Red Hat HA Linux > Storage > PowerVault MD3000i > Introduction

Introduction

The following document will walk-through the hardware, software, and configuration of the Dell PowerVault MD3000i Storage Array and nodes for use in the Dell|Red Hat HA Linux Cluster. This document assumes you have completed the steps in the section System to prepare the nodes.

NOTE: Additional documentation you may find useful:

  • MD3000i official documentation can be found on the MD3000i documentation site.
  • The Dell PowerVault MD3000i Hardware Owners Manual and the Dell PowerEdge System Hardware Owners Manual provide information about the storage array and host servers.
  • The Dell PowerVault MD3000i Systems Installation Guide provides an overview of setting up and cabling your storage array.
  • The PowerVault Modular Disk Storage Manager CLI Guide provides information about using the command line interface (CLI).
  • The Dell PowerVault MD3000i Resource media provides documentation for configuration and management tools, as well as the full documentation set included in this section.
  • The Dell PowerVault Modular Disk Storage Manager User’s Guide provides instructions for using the array management software to configure the storage array.
  • The Dell PowerVault MD3000i Support Matrix provides information on supported software and hardware for PowerVault MD systems. This document can be located on the Dell Support website at support.dell.com.
  • If you are using a different type of storage with your Dell|Red Hat HA Linux Cluster, refer to the Storage index.



Continue to Hardware



Dell|Red Hat HA Linux > Storage > PowerVault MD3000i > Introduction

Personal tools
Distributions