Status |
Displays the status of the controller. |
ID |
Displays the controller ID as reported by the omreport CLI command. |
Name |
Displays the name of the controller. For more
detailed information on a controller, click its name on the controller
name. |
Slot ID |
Displays the slot to which the controller is attached.
Storage Management displays Slot Not Applicable for controllers for which it is unable to display the slot ID and Embedded for embedded controllers. | NOTE: If Slot
Not Available is displayed, you can identify the slot
ID by selecting the object in the tree view
and selecting the Information tab. The Slot ID property on this tab may display the correct
information. |
|
State |
Displays the state of the controller. Possible
values are:
- Ready — The controller is functioning
normally.
- Degraded — The controller has
suffered a failure of a component and is operating in a degraded state.
- Failed — The controller has
suffered a failure of one or more components and is no longer functioning.
|
Firmware Version |
Displays the version of the firmware available
on the controller. |
Minimum Required Firmware Version |
Displays the minimum firmware version that is
required by Storage Management. This property is displayed only if
the controller firmware does not meet the minimum requirement. |
Driver Version |
Displays the version of the drivers installed on
the controller. |
Minimum Required Driver Version |
Displays the minimum driver version that is required
by Storage Management. This property is displayed only if the controller
driver does not meet the minimum requirement. |
Number of Connector |
Displays the number of connectors available on
the controller. Each connector can be attached to physical disks or
an enclosure. Depending on the controller type, the connector can
be either a SCSI channel or a SAS port. |
Rebuild Rate |
The rebuild rate is the percentage of the resources
available on the system dedicated to rebuild a failed disk when a
rebuild is necessary. For more information on rebuild rate, see Setting
The Rebuild Rate. |
Alarm State |
Displays whether the alarm on the controller is
enabled or disabled. |
Cluster Mode |
Indicates whether the controller is part of a
cluster configuration. |